LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2010 >> Sedona Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Rear Area Module Diagnosis >> DTC B2524: Stop Lamps Default Circuit Open Error >> Scantool Diagnostics >> Monitor Scantool Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor Scantool Data

  1. Connect scantool to Data Link Connector (DLC).
  2. Ignition "ON" & engine "OFF"
  3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
  4. Is the DTC B2524 present?

    YES

    1. Go to "INSPECTION & REPAIR " procedure

    NO

    1. Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared.

      Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals