Throttle Position Sensor (TPS)
WARNING: This page is about a different variant/trim than selected.
- Connect GDS on the Data Link Connector (DLC).
- Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.VOLTAGE SPECIFICATION CHART
Throttle Angle Output Voltage (V) TPS 1 TPS 2 C.T 0.25 ~ 0.9 Min.4.0 W.O.T Min.4.0 0.25 ~ 0.9 - Turn the ignition switch OFF and disconnect the GDS from the DLC.
- Disconnect the ETC module connector and measure the resistance between the ETC module terminals 1 and 4.
Specification: Refer to "SPECIFICATION "