Component Inspection: Notes

1. Ignition "ON" & Engine "OFF" and Using a scan tool, clear the DTC
2. Ignition "OFF".
3. Disconnect the battery (-) terminal cable from the battery, and wait at least one minute.
4. Disconnect WCS sensor connector.
5. Substitute the WCS sensor or WCS Module and check for proper operation.
6. Is DTC present problem?

   YES 

   • Substitute a known-good SRSCM, and check for proper operation.

   If the problem is corrected, replace SRSCM and then go to VERIFICATION OF VEHICLE REPAIR  procedure and Go to WCS RESET  procedure.

   NO 

   • Substitute a known-good WCS Sensor or known-good seat assembly or WCS Module, and check for proper operation.

If the problem is corrected, replace WCS Sensor or seat assembly and Go to WCS RESET  procedure.