Input Specification

1. IGN2

   IGN switch input is determined by Local switch "IGN2".

2. SEAT MANUAL switch: SEAT Input
   1. SLIDE Front rear / rear right manual switch

      Operating SLIDE motor of Seat either backward or forward

   2. Recline Front rear / rear right switch

      Operating recline motor of seat either backward or forward

   3. Front rear height UP / DOWN manual switch

      Operating Front rear height motor of SEAT either upward or downward

   4. Rear right height UP / DOWN manual switch

   Operating rear right height motor of SEAT either upward or downward

3. SEAT position Sensor (pulse Signal)

   Sensing movement amount of Slide, Recline, Front rear height, and Rear right height motor

4. "P" Position switch

   Sensing "P" position of SHIFT LEVER, not allowed for memory saving and easy access function by getting on and off a vehicle in the position other than "P."

5. Dr Door switch

   Sensing that drive door opens

6. BCM KEY IN

   This signal is received for sensing state of KEY by BCM

7. Local KEY IN switch

   Sensing whether KEY is inserted or not.

8. Speed

   This signal is received for sensing vehicle speed by BCM

9. IMS switch
   1. SET switch

      Allowing for saving the SEAT position set by driver

   2. 1, 2 switch

   Saving and replaying the SEAT position set by driver

   Transmitting communication signals between IMS switch and MEMORY P/SEAT (9600 bps)

   CHATTERING Control in Input Signal

1. Input switch - 40ms delay

   SLIDE, RECLINE, Front rear height, rear right HEIGHT switch

   "P" Position switch, SPEED, KEY IN, LOCAL KEY IN switch, DR DOOR switch, IGN2 switch

2. IGN switch input is determined by Local switch "IGN2.

TIME Error

1. ±10%, for TIME without error indication

   ±50ms, for TIME not exceeding 500ms

2. Indicated time in each function does not include Time of controlling CHATTERING started from changing point of rr input.