Boost Pressure Sensor (BPS): Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
CAUTION:
- Insert the sensor in the installation hole and be careful not to damage.
- Insert the sensor in the installation hole and be careful not to damage.
- Install in the reverse order of removal.
Boost pressure sensor mounting bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)