LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2012 >> Sedona EX >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Control - Front Area Module Diagnosis >> DTC B2537: Right Turn Signal Lamp Circuit Open Error >> Scantool Diagnostics >> Monitor Scantool Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor Scantool Data

  1. Connect scantool to Data Link Connector (DLC).
  2. Ignition "ON" & engine "OFF" & FAM : "ON".
  3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter.
  4. Is the DTC B2537 present?

    YES

    1. Go to INSPECTION & REPAIR .

    NO

    1. Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared.

      Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to VERIFICATION OF VEHICLE REPAIR  procedure.

scientia non olet · About LEMON Manuals