LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2013 >> Soul Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) & Sensors >> SRS Control Module (SRSCM) >> Repair procedures >> Installation >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Installation: Notes

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM with the SRSCM mounting bolts.

    Tightening torque (SRSCM Mounting Bolt) 

    : 7.8 ~ 9.8 Nm (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb.ft)

    NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
  4. Connect the SRSCM connector (A) and (B) by pushing the lever (3) and lock (1) completely.
    Fig 1: Pushing SRSCM Connector Lever And Lock
    G08328564Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: When installing the airbag wiring harness, ground points(C) must be installed.
  5. Install the floor console. (Refer to the CONSOLE )
  6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals