Throttle Position Sensor (TPS)

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.

Connect the GDS on the Data Link Connector (DLC).

Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.

TPS VOLTAGE SPECIFICATIONS

Throttle Angle	Output Voltage (V)
Throttle Angle	TPS 1	TPS 2
C.T.	0.3 - 0.9	4.2 - 5.0
W.O.T.	1.5 - 3.0	3.3 - 3.8

Turn the ignition switch OFF and disconnect the scan tool from the DLC.
Disconnect the ETC module connector and measure the resistance between the ETC module terminals 1 and 2.

Specification: Refer to "SPECIFICATION "