LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2014 >> Sorento Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Starting System - 2.4L) >> Starter >> Repair Procedures >> Removal And Installation >> Notes
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal And Installation: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable.
  2. Remove the air duct and air cleaner assembly. (Refer to "AIR CLEANER ").
  3. Remove the ETC module. (Refer to ETC - REMOVAL ).
  4. Remove the intake manifold stay (A).
    Fig 1: Starter System Circuit Diagram
    G00550897Courtesy of KIA MOTORS AMERICA, INC.
  5. Disconnect the starter cable (A) from the B terminal on the solenoid, then disconnect the connector (B) from the S terminal.
  6. Remove the 2 bolts (C) holding the starter, then remove the starter.
  7. Remove the 2 bolts holding the starter, then remove the starter (A).
    Fig 2: Identifying Starter Cable, S Terminal Connector & Starter
    G00550898Courtesy of KIA MOTORS AMERICA, INC.
  8. Installation is the reverse of removal.

    Tightening torque: 

    Starter mounting bolt: 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

scientia non olet · About LEMON Manuals