Repair Procedures: Installation

WARNING: This page is about a different car, the 2015 Kia Forte5 and 2015 Kia Forte Koup. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.
CAUTION: If the oil seal on the transaxle case side is damaged and fluid is leaking, replace the oil seal with a new unit. When installing the new oil seal, use the specialized tool (oil seal installer, 09453-3L240).
NOTE:
After replacement or reinstallation procedure of the automatic transaxle assembly, must perform procedures below.
- Adding automatic transaxle fluid.
  (Refer to "FLUID ")
- After replacing the automatic transaxle, clear the Diagnostic Trouble Code (DTC) using the GDS tool. DTC cannot be cleared by disconnecting the battery.
- When replacing the automatic transaxle, reset the automatic transaxle's values by using the GDS.
  
  Fig 1: Display - Resetting Auto T/A Value Screen
  Courtesy of KIA MOTORS AMERICA, INC.
  
  Fig 2: Display - Message Resetting Auto T/A Value Confirmation Screen
  Courtesy of KIA MOTORS AMERICA, INC.
  
  Fig 3: Display - Resetting Auto T/A Value Message Completion Screen
  Courtesy of KIA MOTORS AMERICA, INC.
- Perform TCM learning after replacing the transaxle to prevent slow transaxle response, jerky acceleration and jerky startup. (Refer to "REPAIR PROCEDURES ")