| DTC Strategy |
|
- Open in ground circuit
- Short to battery in signal circuit
- Poor connection or damaged harness
- Faulty TPS1
|
| Case1 |
Enable Conditions |
|
| Threshold Value |
|
| Case2 |
Enable Conditions |
- Ignition "ON"
- Engine operating state idle: Pedal value < 0.01% (pedal sensor 1 voltage 0.83 V, not pushed at all)
- TPS setpoint < 58%
- TPS 1 and TPS 2 ratio failure detected or TPS 2 failure detected
|
| Threshold Value |
|
| Diagnostic Time |
|
| MIL On Condition |
|
| Limp-Home |
- Forced limited power mode: When the DTC is set, the PCM/ECM reduces engine torque by 25% of normal value.
- The PCM/ECM uses TPS2 signal to monitor the controlled opening angle of the throttle valve.
|