LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2015 >> K900 V6 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 3.8L >> Injector >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

Fig 1: Identifying Combustion Seal, Rubber Washer And O-Ring
G10717067Courtesy of KIA MOTORS AMERICA, INC.
CAUTION:
  • Do not reuse the used injector fixing clip.
  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  • Apply engine oil to the injector O-ring.
  • Do not reuse the used injector O-ring.
  • Do not reuse the used bolt.
  • When inserting the injector, be careful not to damage the injector tip.
CAUTION:
  • Do not reuse the support disc.
  • Do not reuse the injector rubber washer.
  • When replacing the rubber washer, the rounded edge (A) part should be faced the cylinder installation part and the angulated edge (B) part should be faced the injector body part.
Fig 2: Identifying Injector Rounded And Angulated Edges
G10717068Courtesy of KIA MOTORS AMERICA, INC.
CAUTION: Do not reuse the combustion seal.
  1. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals