Repair Procedures: Installation: Adjustment
- After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using GDS.
- After finishing "ECM Neutral Mode", perform
"Key Teaching" procedure using GDS.
[If installing a new ECM]
Perform "Key Teaching" procedure using GDS.
- After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "Smart key System - REPAIR PROCEDURES ")
- After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
[If installing a new ECM]
Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.