LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2015 >> Soul Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM), Occupant Detection System & Sensors >> SRS Control Module (SRSCM) >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM with the SRSCM mounting bolts.

    Tightening torque (SRSCM Mounting Bolt): 

    7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)

    Fig 1: Identifying SRSCM Mounting Bolts Of Ground Points
    G09773440Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Use new mounting bolts when replacing the SRSCM after a collision.
    • When installing the airbag wiring harness, ground points (C) must be installed.
  4. Connect the SRSCM harness connector.
  5. Install the rear heating joint duct.
  6. Install the floor console.

    (Refer to "FLOOR CONSOLE ")

  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
      CAUTION: SRSCM is sensing the vehicle rollover. SAB, CAB, BPT will be able to expanse if mechanic moves the SRSCM on vehicle during IGN ON state. For this reason, turn the IGN OFF surely and then remove the SRSCM from vehicle.
scientia non olet · About LEMON Manuals