LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2015 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Front Seat Assembly) >> Front Seat Frame Assembly >> Repair Procedures >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Put on gloves to protect your hands.
  • Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury
NOTE:
  • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the front seat back cover.

    (Refer to Front Seat - "FRONT SEAT BACK COVER ")

  2. Remove the front seat cushion cover.

    (Refer to Front Seat - "FRONT SEAT CUSHION COVER ")

  3. Disconnect the connector (A).
  4. After loosening the mounting bolts, separate the front seat back frame assembly (B) and front seat cushion frame assembly (C).

    Tightening Torque: 

    44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

    Fig 1: Separate Front Seat Back Frame Assembly And Front Seat Cushion Frame Assembly
    G11934188Courtesy of KIA MOTORS AMERICA, INC.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals