Repair Procedures: Installation

WARNING: This page is about a different car, the 2015 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.

Remove the ignition key from the vehicle.
Disconnect the battery negative cable from the battery and wait for at least thirty seconds before beginning to work before beginning work.
Place a passenger airbag on the crash pad and tighten the passenger airbag (A) mounting bolts.

Fig 1: Passenger Airbag And Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Install the crash pad.
(Refer to Body - "MAIN CRASH PAD ASSEMBLY ")
Connect the passenger airbag connector (B).

Fig 2: Passenger Airbag Connector And Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Tighten the passenger airbag mounting bolts (A).
Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Reinstall the glove box housing.
(Refer to Body - "GLOVE BOX HOUSING ")
Reconnect the battery negative cable.
After installing the passenger airbag (PAB), confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.