LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2016 >> Cadenza Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Blind Spot Detection System Diagnosis >> DTC C2702-54: Control Module Master Missing Calibration >> DTC Inspection >> Monitor GDS Data >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor GDS Data: Notes

  1. Connect GDS to Data Link Connector (DLC).
  2. IG key "ON".
  3. Monitor "Diagnostic Trouble Codes (DTC) "  .
  4. Are any DTCs present?

    YES 

    • Go to "BSD Radar Calibration" procedure.

    NO 

    • Fault is intermittent caused by poor contact in the BSD ECU's connector or was repaired and BSD ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals