Component Inspection

■ Check auto cruise switch 

1. IG "OFF" and disconnect Cruise switch connector.
2. Measure resistance between signal and power terminals of Cruise switch connector with each switch depressed. (Component side)
3. Measure resistance between signal and ground terminals of Cruise switch connector with each switch depressed. (Component side)

   Specification: 

   Item	Resistance (Ω)
   ON/OFF switch	3.9 kΩ ± 5%
   SET switch	220 Ω ± 5%
   RESUME switch	910 Ω ± 5%
   CANCEL switch	0 Ω ± 5%

4. Is the measured resistance within specification?

   YES 

   • Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

   NO 

   • Substitute with a known - good auto cruise switch and check for proper operation. If the problem is corrected, replace auto cruise switch and go to "VERIFICATION OF VEHICLE REPAIR " procedure.