Signal Circuit Inspection

■ Check voltage 

1. IG "OFF" and disconnect Cruise switch connector.
2. IG "ON"
3. Measure voltage between signal terminal of Cruise switch harness connector and chassis ground.

   Specification:  Approx. 5V

4. Is the measured resistance within specification?

   YES 

   • Go to "Check open in harness" below.

   NO 

   • Repair short in control harness and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

■ Check open in harness 

1. IG "OFF" and disconnect Cruise switch connector and PCM connector.
2. Measure resistance between signal terminal of Cruise switch harness connector and cruise signal terminal of PCM harness connector.

   Specification:  Approx. below 1Ω

3. Is the measured resistance within specification?

   YES 

   • Go to "COMPONENT INSPECTION " procedure.

   NO 

   • Repair open in harness, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.