Signal Circuit Inspection

■ Check short to battery in harness 

1. IG "OFF". Disconnect APS connector and PCM connector.
2. Measure resistance between APS1 signal and APS1 power terminals of APS harness connector.
3. Measure resistance between APS1 signal and APS2 power terminals of APS harness connector.

   Specification:  Infinite

4. Is the measured resistance within specification?

   YES 

   • Go to "GROUND CIRCUIT INSPECTION " procedure.

   NO 

   • Repair short to battery in harness. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.