Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn the ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the accelerator position sensor connector (A).

Fig 1: Locate Accelerator Position Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the installation bolt (B), the nuts (C) and then remove the accelerator pedal module.

Fig 2: Remove Accelerator Pedal Module

Courtesy of KIA MOTORS AMERICA, INC.

Fig 3: Remove Installation Bolt, Nuts

Courtesy of KIA MOTORS AMERICA, INC.