Component Inspection
- IG KEY "OFF".
- Disassemble Fuel Level Sender "A".
- Measure resistance between signal terminal and ground terminal of Fuel Level Sensor "A" with moving the float. (Component side)
Specification: Variation (6 ~ 202 Ω) with moving the float.
- Is resistance within the specification?
YES
- Check for poor connection between PCM/ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification Of Vehicle Repair " procedure.
NO
- Substitute with a known-good component and check for proper operation. If the problem is corrected, replace it and then go to "Verification Of Vehicle Repair " procedure.