April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Adjustment

WARNING: This page is about a different variant/trim than selected.

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures")
2. After finishing "ECM Neutral Mode", perform "KEY TEACHING " procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures")
  [If installing a new ECM]
  
  Perform "KEY TEACHING " procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures")
After replacing the ECM of the vehicle with the Smart Key System (button start), the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures")
2. After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
[If installing a new ECM]

Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.