Repair Procedures: Installation

Install in the reverse order of removal.
NOTE:
- Do not reuse the drain plug gasket and the valve body cover gasket, oil cooler tube washer.
- Perform the procedures below after installing
1. Refill the automatic transaxle with fluid.
  (Refer to Fluid .)
2. Refill the engine & transaxle cooling system with coolant.
  (Refer to Coolant . .)
3. Refill the hybrid motor cooling system with coolant and then perform the air bleeding using the GDS.
  (Refer to Coolant . )
4. Reset the automatic transaxle adaptive values using the GDS.
5. Confirm the coolant leak or fluid leak from the hose connections part in state of engine start.