Repair Procedures: Installation

Install in the reverse order of removal.
NOTE:
- Do not reuse the drain plug gasket and the valve body cover gasket, oil cooler tube washer.
- Perform the procedures below after installing
1. Refill the automatic transaxle with fluid.
  (Refer to Fluid .)
2. Refill the engine & transaxle cooling system with coolant.
  (Refer to Coolant .)
3. Refill the hybrid motor cooling system with coolant and then perform the air bleeding using the GDS.
  (Refer to Coolant .)
4. Reset the automatic transaxle adaptive values using the GDS.
5. Confirm the coolant leak or fluid leak from the hose connections part in state of engine start.