Connector [C200-AA]
WARNING: This page is about a different variant/trim than selected.
| Pin No. | Description | Condition | Type | Level |
|---|---|---|---|---|
| 1 | Injector (Cylinder #1) [High] control output | Relay ON/OFF | DC | 71V |
| 2 | Injector (Cylinder #4) [High] control output | Relay ON/OFF | DC | 71V |
| 3 | Injector (Cylinder #2) [High] control output | Relay ON/OFF | DC | 71V |
| 4 | Injector (Cylinder #3) [High] control output | Relay ON/OFF | DC | 71V |
| 5 | - | |||
| 6 | - | |||
| 7 | Purge Control Solenoid Valve (PCSV) control output | Relay OFF | DC | Battery voltage |
| Relay ON | Max. 1.76V | |||
| 8 | Stare Relay output [With ISG] | |||
| 9 | - | |||
| 10 | - | |||
| 11 | Sensor power (+5V) | IG OFF | DC | Max. 0.5V |
| IG ON | 4.9 ~ 5.1V | |||
| 12 | Throttle Position Sensor (TPS) 1 signal input | Idle | Analog | 0.33 ~ 4.72 V |
| 13 | Sensor ground | Idle | DC | Max. 50mV |
| 14 | - | |||
| 15 | Sensor power (+5V) | IG OFF | DC | Max. 0.5V |
| IG ON | 4.9 ~ 5.1V | |||
| 16 | - | |||
| 17 | - | |||
| 18 | Sensor power (+5V) | IG OFF | DC | Max. 0.5V |
| IG ON | 4.9 ~ 5.1V | |||
| 19 | Sensor power (+5V) | IG OFF | DC | Max. 0.5V |
| IG ON | 4.9 ~ 5.1V | |||
| 20 | - | |||
| 21 | - | |||
| 22 | - | |||
| 23 | - | |||
| 24 | Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 1] heater control output | Relay OFF | DC | Battery voltage |
| Relay ON | Max. 1.65V | |||
| 25 | Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 2] heater control output | Relay OFF | DC | Battery voltage |
| Relay ON | Max. 1.65V | |||
| 26 | - | |||
| 27 | - | |||
| 28 | - | |||
| 29 | - | |||
| 30 | - | |||
| 31 | - | |||
| 32 | Sensor ground | Idle | DC | Max. 50mV |
| 33 | - | |||
| 34 | Throttle Position Sensor (TPS) 2 signal input | Idle | Analog | 0.55 ~ 4.37 V |
| 35 | - | |||
| 36 | - | |||
| 37 | - | |||
| 38 | - | |||
| 39 | - | |||
| 40 | - | |||
| 41 | Sensor ground | Idle | DC | Max. 50mV |
| 42 | - | |||
| 43 | - | |||
| 44 | - | |||
| 45 | - | |||
| 46 | - | |||
| 47 | - | |||
| 48 | - | |||
| 49 | - | |||
| 50 | - | |||
| 51 | Alternator electric load signal input | Idle | Pulse | High: Battery voltage |
| Low: Max. 1.5V | ||||
| 52 | - | |||
| 53 | Brake switch signal input | ON | DC | Battery voltage |
| OFF | Max. 2.25V | |||
| 54 | Accelerator Position Sensor (APS) 1 signal input | Idle | Analog | 0.674 ~ 4.379 V |
| 55 | - | |||
| 56 | Accelerator Position Sensor (APS) 2 signal input | Idle | Analog | 0.261 ~ 2.204 V |
| 57 | - | |||
| 58 | - | |||
| 59 | - | |||
| 60 | Sensor ground | Knocking | Variable | |
| Normal | Frequency | |||
| 61 | Knock Sensor (KS) signal input | Knocking | Variable | |
| Normal | Frequency | |||
| 62 | Sensor ground | Idle | DC | Max. 50mV |
| 63 | Sensor ground | Idle | DC | Max. 50mV |
| 64 | Injector (Cylinder #1) [Low] control output | Relay OFF | DC | 71V |
| Relay ON | Max. 1.0V | |||
| 65 | Injector (Cylinder #4) [Low] control output | Relay OFF | DC | 71V |
| Relay ON | Max. 1.0V | |||
| 66 | Injector (Cylinder #2) [Low] control output | Relay OFF | DC | 71V |
| Relay ON | Max. 1.0V | |||
| 67 | Injector (Cylinder #3) [Low] control output | Relay OFF | DC | 71V |
| Relay ON | Max. 1.0V | |||
| 68 | - | |||
| 69 | - | |||
| 70 | - | |||
| 71 | - | |||
| 72 | - | |||
| 73 | - | |||
| 74 | - | |||
| 75 | - | |||
| 76 | - | |||
| 77 | Fuel Tank Pressure Sensor (FTPS) signal input | Idle | Analog | 0.3343 ~ 0.4667V |
| 78 | Fuel Level signal input | Idle | Analog | 0.193 ~ 4.0V |
| 79 | - | |||
| 80 | - | |||
| 81 | - | |||
| 82 | Engine Coolant Temperature Sensor (ECTS) signal input | Idle | Analog | 0.270 ~ 4.77V |
| 83 | VS-/IP- (Common Ground for VS, IP) | Idle | DC | Max. 50mV |
| 84 | VS+ (NERNST Cell Voltage) | Idle | Analog | 0 ~ 5.1V |
| 85 | Fuel Pressure Control Valve (FPCV) [Low] control output | Relay OFF | DC | 16V |
| Relay ON | Max. 1.0V | |||
| 86 | Fuel Pressure Control Valve (FPCV) [High] control output | Relay ON/OFF | DC | 16V |
| 87 | - | |||
| 88 | - | |||
| 89 | - | |||
| 90 | - | |||
| 91 | - | |||
| 92 | - | |||
| 93 | - | |||
| 94 | - | |||
| 95 | - | |||
| 96 | - | |||
| 97 | - | |||
| 98 | - | |||
| 99 | - | |||
| 100 | - | |||
| 101 | - | |||
| 102 | - | |||
| 103 | Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 2] signal input | Engine | Analog | Rich: 0.6 ~ 1.0V |
| Running | Lean: Max. 0.4V | |||
| 104 | Rc/Rp (Pump Cell Voltage) | Idle | Analog | 0 ~ 5.1V |
| 105 | Rc (Compensative Resistance) | Idle | Analog | 0 ~ 5.1V |