Component Inspection
- Ignition "OFF"
- Connect KDS/GDS to Data Link Connector (DLC).
- Ignition "ON"
- Monitor "Diagnostic Trouble Codes (DTC)" with KDS/GDS.
- Clear any DTCs stored in the system with KDS/GDS.
- Re-check DTC in the system with KDS/GDS.
- Is the same DTC stored in the system?
YES
- Carefully re-do this troubleshooting guide steps.
- Verify that DTC is cleared when you remove the unit/module connectors that make up the M-CAN communication.
- If no problems were found with the circuits or connectors, replace the concerned unit/module and then go to "Verification Of REPAIR " procedure.
NO
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "Verification Of REPAIR " procedure.