Monitor KDS/GDS Data
- Connect KDS/GDS to Data Link Connector (DLC).
- Engine "ON".
- Operate Shift Lever.
- Monitor "Shift Lever Switch" and "Sports Mode Switch" parameter in "Current Data" with KDS/GDS.
Specification : Refer to Fig 1 below
- Is displayed parameter within specification?
YES
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "Verification Of REPAIR " procedure.
NO
- Go to "WIRING INSPECTION " procedure.