Control Circuit Inspection

■ Check Open or Short in FPR circuit

1. IG KEY "OFF".
2. Disconnect FPR connector.
3. IG KEY "ON" & ENG "OFF"
4. Measure the voltage between FPR open, FPR close terminal of FPR harness connector and chassis ground.

   Specification  :

   FPR open Terminal: Approx. 0~0.6V

   FPR close Terminal: Approx. 0.6V

5. Is the measured voltage within specification?

   YES 

   • Go to "Component Inspection " procedure.

   NO 

   • Check for Open or Short in FPR circuit. Repair as necessary and then go to "Verification of Vehicle Repair " procedure.