LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2017 >> Forte LX, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Multi Function Camera Diagnosis) >> DTC C1623-87: CAN Time-out Steering Angle Sensor >> Component Inspection >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

WARNING: This page is about a different car, the 2018 Kia Forte5 and 2018 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF"
  2. Connect KDS to Data Link Connector (DLC).
  3. Ignition "ON"
  4. Monitor "Diagnostic Trouble Codes (DTC)"  with KDS.
  5. Clear any DTCs stored in the system with KDS.
  6. Re-Check DTC in the system with KDS.
  7. Did the same DTC is stored in the system?

    YES 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace Steering Angle Sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals