Component Inspection

INSPECTION PART - IGPM AND ECM COMPONENTS INSPECTION

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the Battery (-) Cable. Disconnect the Electrical Connector(s) from the component. SMK and ECM.	IGPM component	2 (P-CAN High)	IGPM component	1 (P-CAN High)	Approx. 120 Ω
	ECM component	55 (P-CAN Low)	ECM component	77 (P-CAN Low)	Approx. 120 Ω

Good	If no problems were found with the circuits or connectors, check the MOTOR CONTROL UNIT (MCU) and go to "Verification Of Repair " procedure.
No Good	If no problems were found with the circuits or connectors, replace the IGPM or ENGINE CONTROL MODULE (ECM) and go to "Verification Of Repair " procedure.