Control (Low) Circuit Inspection
- Ignition "OFF".
- Refer to FUEL PRESSURE REGULATOR and disconnect Fuel Pressure Regulator connector.
- Ignition "ON"
- Measure voltage between Pin No. 2 (Low) terminal of Fuel Pressure Regulator harness connector and chassis ground.
Specification: Approx. 4.4V
- Is the measured value within specification?
YES
- go to "Component Inspection " procedure.
NO
- Repair open or short in control (High) circuit between Fuel Pressure Regulator and ECM/PCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.