DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
Case 1	DTC Strategy	Check motor torque_Dry run (Low load)	Coolant quantity Poor battery Poor Connection Short to power in signal circuit Open in ground circuit Faulty EWP
	Enable Conditions	Motor speed is faster than 2, 000 RPM Battery voltage is between 9V and 16.5V Torque is lower than 0.0251Nm
	Threshold Value	Coolant quantity is low
	Diagnosis Time	5s
	MIL ON Condition	2 driving cycles
Case 2	DTC Strategy	Check motor torque (Over load)
	Enable Conditions	Battery voltage is between 9V and 16.5V Torque is higher than 0.58Nm
	Threshold Value	Coolant quantity is too much
	Diagnosis Time	1s
	MIL ON Condition	2 driving cycles
Case 3	DTC Strategy	Check motor speed
	Enable Conditions	Battery voltage is between 11V and 16.5V The difference between target speed and actual speed is greater than 5%
	Threshold Value	Pump rotation speed error
	Diagnosis Time	5s
	MIL ON Condition	2 driving cycles