| DTC Strategy |
Case 1~3 |
- Level 2 monitoring (=Process monitoring)
|
- Poor Connector Connection
- Faulty PCM
|
| Case 4 |
- Check RAM Area/communication connections
|
| Case 5 |
- Level 3 monitoring (=Process monitoring)
|
| Enable Condition |
Case 1 |
- Ignition Switch "ON" or engine running
|
| Case 2~3 |
|
| Case 4~5 |
|
| Threshold Value |
Case 1 |
- Actual value is higher or lower than allowable range
|
| Case 2 |
- Too high Engine Speed in case of ETC Limp Home
|
| Case 3 |
|
| Case 4 |
- RAM test/Checksum/SPI communication failure
|
| Case 5 |
- RAM/ROM error on microcontroller Checksum check Communication between Main controller and Monitoring unit Process Monitoring test calculation failed
|
| Diagnostic Time |
Case 1~3 |
|
| Case 4 |
|
| Case 5 |
|
| MIL ON Condition |
|