Check TPS performance
- IG KEY "OFF".
- Connect CH A probe to TPS1 signal terminal(Pin No. 6) of ETC Motor connector and CH B probe to TPS2 signal terminal(Pin No. 4) of ETC Motor connector.
- Warm up the engine to normal operating temperature.
- Measure signal waveform of TPS1 and TPS2 together by stepping on and off the accelerator pedal.
Specification: Refer to SIGNAL WAVEFORM & DATA below
- Does the TPS operate properly? (Check variation)
YES
- Go to "SYSTEM INSPECTION " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the ECT Motor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.