LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2017 >> Sedona L >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (3 Of 3) >> DTC P0611: Fuel Injector Control Module Performance >> Component Inspection >> Injector Resistance Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Injector Resistance Inspection

  1. Ignition "OFF"
  2. Disconnect Battery (-) terminal.
  3. Refer to INJECTOR DRIVE BOX (IDB) and disconnect Injector connector.
  4. Measure the resistance between Pin No. 2 (high) terminal and Pin No. 1 (low) terminal of Injector.

    Specification:  Approx. 1.25Ω at 68°F(20°C)

  5. Is measured value within specification?

    YES 

    • Carefully re-do this troubleshooting guide steps.
    • If the diagnostics have been performed correctly with no failure found, replace the IDB and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace the Injector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals