ECM Neutral Mode Procedure
WARNING: This page is about a different variant/trim than selected.
- After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using GDS. (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")
- After finishing "ECM Neutral Mode", perform
"TEACHING PROCEDURES
" procedure using GDS. (Refer to
Body Electrical System - "Immobilizer System - REPAIR PROCEDURES
")
[If installing a new ECM]
Perform "TEACHING PROCEDURES " procedure using GDS. (Refer to Body Electrical System - "Immobilizer System - REPAIR PROCEDURES ")
- After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If installing a used ECM]
- Perform "ECM Neutral Mode" procedure using GDS. (Refer to Body Electrical System - "Smart Key System - REPAIR PROCEDURES ")
- After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
[If installing a new ECM]
Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.