Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the shift cable retainer (A) by tightening nuts (B).
Tightening torque:
11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb.ft)
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Install the cable sockets (A).
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Install the shift cable (A).
[A Type]
 Courtesy of KIA MOTORS AMERICA, INC.
|
NOTE:
Matters that require attention when installing the shift cable.
- Push the cable end to shift lever rod with supporting with finger.
 Courtesy of KIA MOTORS AMERICA, INC.
|
- With holding side of cable end eye or cable rod, push the shift lever rod into shift cable eye end until hearing clicking sound.
 Courtesy of KIA MOTORS AMERICA, INC.
|
- After assembling, make sure that this part is extruded.
 Courtesy of KIA MOTORS AMERICA, INC.
|
[B Type]
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Install the select cable to the lever pin and then insert the snap pin (A).
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Check that the shift lever and control shaft are placed in the "4th" position and then install the 4th fixing pin (A).
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Install the control cable.
- After pulling the holder (A) in the direction of the "P", pull the lock (B) in the direction of the "F".
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Push the lock (A) after installing the control cable to the control shaft and cable bracket.
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Insert the snap pins (A).
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Remove the 4th fixing pin (A).
 Courtesy of KIA MOTORS AMERICA, INC.
|
- Check for proper operation of control shaft lever when operated (1st, 2nd, 3rd, 4th, 5th, 6th, R gear).
- Install the battery and battery tray.
(Refer to Engine Electrical System - " BATTERY
")
- Install the air cleaner assembly.
(Refer to Engine Mechanical System - " AIR CLEANER
")
- Install the floor console assembly.
(Refer to Body - " FLOOR CONSOLE ASSEMBLY
")