ECM Neutral Mode procedure

WARNING: This page is about a different car, the 2017 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM NEUTRAL MODE " procedure using GDS. (Refer to REPAIR PROCEDURES "Body Electrical System - "Immobilizer System - Repair procedures")
2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using GDS. (Refer to REPAIR PROCEDURES "Body Electrical System - "Immobilizer System - Repair procedures")
[If installing a new ECM]

Perform "Key Teaching" procedure using GDS. (Refer to REPAIR PROCEDURES "Body Electrical System - "Immobilizer System - Repair procedures")
After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If installing a used ECM]
1. Perform "ECM NEUTRAL MODE " procedure using GDS. (Refer to REPAIR PROCEDURES "Body Electrical System - "Smart key System - Repair procedures")
2. After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
[If installing a new ECM]

Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.

TCM learning procedure

Perform TCM learning after replacing the PCM.
(Refer to Automatic Transaxle Control System - "ADJUSTMENT ")

ETC module learning procedure

Perform ETC module learning after replacing the ETC module.
(Refer to Electronic Throttle Control System - "ADJUSTMENT ")