Power Circuit Inspection
WARNING: This page is about a different car, the 2019 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition "OFF"
- Refer to "REMOVAL " and disconnect Front Right PAS Sensor connector.
- Ignition "ON"
- Measure voltage between Pin No. 6 (Power) terminal of front right PAS sensor harness connector and chassis ground.
Specification: Approx. 12 V
- Is measured value within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in power circuit between Front Right PAS Sensor and Battery and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.