Repair Procedures: Installation
WARNING: This page is about a different car, the 2019 Hyundai Ioniq, 2018 Hyundai Ioniq, and 2017 Hyundai Ioniq. However, it is still accessible from the selected car via links, so may be relevant.
- Install in the reverse order of removal.
- Connect the 3-phase power cable of U, V, W in the correct position.CAUTION:
- If the power cable is incorrectly assembled, it may result in serious damage in inverter, drive motor, and high voltage battery. In addition, it may also cause injury to driver or service engineer. As a result, for this reason, take caution when assembling the power cable.
- Fill the coolant and then check for leakage.NOTE:
- Refill the motor cooling system with coolant and then bleed the air using the GDS. (Refer to Motor Cooling System - "COOLANT ")
- Install the motor assembly then perform "Initialization of Automatic Resolver Offset Calibration" procedure. Refer to - "INITIALIZATION OF MOTOR/HSG RESOLVER CALIBRATION
".NOTE:
- If "Initialization of Automatic Resolver Offset Calibration" is not reset after exchanging the motor, it may result in reduced max power output as well as drive range.
(Refer to Motor & Reduction Gear - "MOTOR POSITION AND TEMPERATURE SENSOR ")
- If "Initialization of Automatic Resolver Offset Calibration" is not reset after exchanging the motor, it may result in reduced max power output as well as drive range.