Check Short To Battery In CAN Communication Line
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF".
- Disconnect all related module connectors.
- Ignition ON/Hybrid Ready (Cluster Indicator "READY" On)
- Measure voltage between Pin No. 13 (High) terminal of IGPM and chassis ground.
- Measure voltage between Pin No. 14 (Low) terminal of IGPM and chassis ground.
Specification: Approx. 0V
- Is the measured voltage within specification?
YES
- Go to Check Short To Ground In CAN Communication Line procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF REPAIR " procedure.