ETC Module Learning Procedure
WARNING: This page is about a different car, the 2020 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
Be sure to perform the ETC module learning procedure when replacing or re-installing the ETC module.
- Wait for 1 minute with the ignition switch ON.
- Start the engine and hold the idle status for 15 minutes.
- Waif for 1 minute with the ignition switch OFF.
- Restart the engine, check that the idle speed is stable.NOTE: if the ETC module learning procedure is not performed after replacing or re-installing, MIL illumination with DTCs may occur.