Repair Procedures: Installation

WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure below.

[In The Case Of Installing Used ECM]

Perform "ECM Neutral Mode" procedure with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
After finishing "ECM Neutral Mode", perform "Key Teaching" procedure with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")

[In The Case Of Installing New ECM]

Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")

Install in the reverse order of removal.
ECM Installation Bolt:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

ECM Bracket Installation Bolt:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)