Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the battery. (Refer to Engine Electrical System - "BATTERY ")
Disconnect the ECM Connector (A).
Remove the mounting bolts (B) and nut (C), and then remove the ECM bracket assembly.

Fig 1: Locating ECM Connector, Mounting Bolts And Nut
Courtesy of KIA MOTORS AMERICA, INC.
Remove the ECM after removing the nuts (A) from the bracket.

Fig 2: Locating ECM Bracket Nuts
Courtesy of KIA MOTORS AMERICA, INC.