Power Circuit Inspection
- Ignition "OFF"
- Refer to "FUEL PUMP CONTROL MODULE (FPCM) " and disconnect Fuel Control Module connector.
- Ignition "ON"
- Perform "Fuel Pump Relay" in "Actuation Test" with KDS.
- Measure voltage between Pin No. 10 (Signal) terminal of Fuel Control Module harness connector and chassis ground.
Specification: B+
- Is measured value within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in Power circuit of Fuel Control Module and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.