ELCM Pressure Sensor Power Circuit Inspection
- Ignition "OFF"
- Refer to "EVAPORATION LEAK CHECK MODULE (ELCM) " and disconnect ELCM connector.
- Ignition "ON"
- Measure voltage between Pin No. 7 (Power) terminal of ELCM harness connector and chassis ground.
Specification: 5V
- Is measured value within specification?
YES
- Go to "ELCM PRESSURE SENSOR SIGNAL CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in harness. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.