Test Drive

WARNING: This page is about a different car, the 2020 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Be sure to perform test drive to check for normal operation after performing calibration.
Drive on straight road (of longer than 500 m) with 2 white or yellow lane marks at speed of over 60km/h (64mph), and check for the alert as you intentionally steer close to the lane mark.
LKA operates properly if the lane mark segment space is less than 8 m.
Perform test drive on car-only road or on a highway.

NOTE: The LKA may not activate properly in the following conditions
The LKA may not activate properly when:

It is difficult to distinguish the lane from the road due to dust built up on the lane.
It is difficult to distinguish the color of the lane line from the road.
There is a mark that looks like a lane line near the line.
The lane line is indistinct or damaged.
The number of lanes increases or decreases or the lane lines are crossing (driving through toll plaza, toll gate, road merging or dividing area, etc.).
There are more than two lane lines.
The lane is very wide or narrow.
The lane is not visible due to snow, rain, stain, a puddle or other factors.
Shadows of objects (median strip, guard rail, noise barriers, etc.) surrounding the road are cast on the lane.
The lane is congested or it is replaced by a structure in a construction area.
There is a indication on the road surface such as crosswalk or road signs.
The lane inside the tunnel is covered with dust or oil.
The brightness outside changes suddenly such as when entering or exiting a tunnel.
The head lamps are not on at night or in a tunnel, or light level is low.
There is a boundary structure.
Light such as street light, sunlight or oncoming vehicle light reflects from the water on the road.
Driving with the sun in front of you.
Driving on the bus-only lane or on the left/right of the lane.
The lane suddenly disappears at certain locations such as at the intersection.
The distance from the vehicle ahead is extremely short or that vehicle drives hiding the lane line.
Driving on a steep grade or a sharp curve.
The vehicle vibrates heavily.
The surrounding of the inside rear view mirror temperature is high due to direct sun light.
The lens or windshield is covered with foreign matter.
The sensor cannot detect the lane because of fog, heavy rain, or heavy snow.
The windshield is fogged by humid air in the vehicle.
Putting something on the crash pad.

NOTE: The LKA may not activate properly in the following conditions:

The LKA is a system to prevent lane departure and assist steering. In any case, do not rely on the steering assist system, and the driver must take the necessary precautions to determine safety matters.
- Driver is responsible for being aware of surroundings and steering the vehicle for safe driving practices.
- Do not steer the steering wheel suddenly when the steering wheel is being assisted by the system.
- LKA helps prevent the driver from moving out of the lane unintentionally by assisting the driver's steering.
- LKA is not working if the camera cannot detect the lane or if the vehicle speed does not exceed 64km/h (40mph),
- Do not disassemble front view camera temporarily for tinted window or attaching any types of coatings and accessories.
- Do not allow any water or liquid to contact the front view camera.
- Do not remove the front view camera parts and do not damage the front view camera by a strong impact.
- Do not put objects that reflect light on the crash pad.
- Excessive noise can make the LKA alarm sound unheard.