Repair Procedures: Installation

WARNING: This page is about a different car, the 2020 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure.
Use a SST (09581-2T100) when installing the brake caliper assembly.
NOTE:
- Connect an air hose (B) to the SST after confirming that the valve (A) of the SST is surely closed.
- Input the SST in the caliper and press the caliper piston while opening the valve (A) of the SST slowly counter clock wise.
- Close the valve (A) of the SST and disconnect the air hose (B); then, open the valve again to get the rest of air out and remove the SST from the caliper.
Courtesy of HYUNDAI MOTOR AMERICA
After installing, bleed the brake system.
(Refer to Brake System - "BRAKE SYSTEM BLEEDING ")

(Refer to Brake System - "ABS SYSTEM BLEEDING ")

(Refer to Brake System - "ESP SYSTEM BLEEDING ")