Removal And Installation

WARNING: This page is about a different car, the 2024 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the battery.
(Refer to Engine Electrical System - "BATTERY ")
Disconnect the ECM connector (A).
Remove the mounting bolts and nut, and then remove the ECM bracket assembly (B).
Tightening torque:

9.8 - 11.8 Nm (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Remove the ECM (B) after loosening the mounting nuts (A) from the bracket.
Tightening torque:

9.8 - 11.8 Nm (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.

Install in the reverse order of removal.
NOTE:
- Install the Engine Control Module (ECM) to the specified torque.
- If the ECM is dropped, it may cause internal damage. (Do not reuse)